Hi Matt, it's quite complex scenario which we had faced. I have published this issue in our esteemed community to get any solution if anyone has face the same issue and overcome with better solution than us. This is the scenerio in our case which does not bring glory although it could not bring any blame for us till now. Once the wired link get failed, the client need to enable the ethernet interface to bring up the link. The client had to keep disable the ethernet interface till his wired network goes down. However, Cambium Networks had took initial initiative but could not succeed and the issue of STP in the network hanged there till date. Our main struggle point in troubleshooting this case is basically arises no OEM(Cisco and Cambium Networks) took the leadership of the issue which is quite understandable. In the meantime, till date we could not able to make the redundant network as automatic changeover type as spanning tree doesnot work in that particular production network which when run on test lab with same setup works smoothly. We could overcome the issue and the network is working fine till date.
Troubleshoot cisco mac address table cisco 2960x update#
After observing and regorous inspection of traffic behaviour of the network, we had discovered that the Cisco switches could not able get update of radio MAC address in its MAC table due to which we had to manually gave entry in the switches. Later on we had resolve the issues by manually configure MAC of Cambium Networks AP and SM in core and edge switches. In initial stage, we have faced a lot of issues which arises from competibility between Cambium Networks and Cisco switches.
Due to frequent link failure of wired network which severely hamper production of the refinery, they have finally adopted our solution to overcome the downtime issue. We had installed a PMP450 network in year 2015 in one of the refinery located in NE India.The refinery already had a wired back bone across the plant area.